home

Mobile Endpoint Security

Mobile Endpoint SecuritySecurity Service Edge
Mobile Endpoint SecuritySecurity Service Edge

Lookout Product Documentation

Find answers about using and optimizing Lookout products.

Show Contents

Mobile Endpoint Security

Deploying Lookout for Work

Verify the Jamf Pro Configuration

Check the custom attribute to verify the "Activation" and "Risk" attributes are set on the device. Perform this step after one or more devices are activated.

  1. In the Jamf Pro console, click Devices > Search Inventory, then click Search without entering any search parameters.
  2. In the All Devices screen, click a device that is activated.
  3. Click the category which you chose when creating the four .
  4. Note these values are present:
    • Activation is Activated.
    • Issue level is None or Low.

    No values for these attributes indicate an error. Check with Lookout support for more information.

Last updated: September 30, 2024

lookout-footer

Legal Privacy Policy Cookie Policy Transparency Report Compliance Info Compliance Info (Gov)

© 2024 Lookout, Inc. LOOKOUT®, the Lookout Shield Design®, LOOKOUT with Shield Design® and the Lookout multi-color/multi-shaded Wingspan Design® are registered trademarks of Lookout, Inc. in the United States and other countries. DAY OF SHECURITY®, LOOKOUT MOBILE SECURITY®, and POWERED BY LOOKOUT® are registered trademarks of Lookout, Inc. in the United States. Lookout, Inc. maintains common law trademark rights in EVERYTHING IS OK, PROTECTED BY LOOKOUT, CIPHERCLOUD, and the 4 Bar Shield Design.