Creating Custom Attributes for Device State Sync

Lookout uses MaaS360 Custom Attributes to synchronize device state to MaaS360. These attributes are required to configure the MaaS360 Connector in the Lookout MES Console. To add them:

In the MaaS360 Admin Portal, navigate to DEVICES > Device Attributes and click Manage Custom Attributes:

Click Add Custom Attribute and create the following attributes:

Note:

IMPORTANT: These values are case-sensitive.


Attribute Name	Attribute Type	Possible values
`lookout_device_state`	Enum	`none` (default) `securedthreats_detecteddeactivatedpending`
`lookout_activation_state`	Enum	`pending` (default) `activated deactivated`
`lookout_threat_level`	Enum	`none` (default) `lowmediumhigh`
`lookout_disconnected`	Boolean
`lookout_unreachable`	Boolean

lookout-footer

© 2024 Lookout, Inc. LOOKOUT®, the Lookout Shield Design®, LOOKOUT with Shield Design® and the Lookout multi-color/multi-shaded Wingspan Design® are registered trademarks of Lookout, Inc. in the United States and other countries. DAY OF SHECURITY®, LOOKOUT MOBILE SECURITY®, and POWERED BY LOOKOUT® are registered trademarks of Lookout, Inc. in the United States. Lookout, Inc. maintains common law trademark rights in EVERYTHING IS OK, PROTECTED BY LOOKOUT, CIPHERCLOUD, and the 4 Bar Shield Design.

Lookout Product Documentation

Find answers about using and optimizing Lookout products.

Creating Custom Attributes for Device State Sync

lookout-footer