Using Lookout Risk Levels to Drive Compliance Rules

MaaS360 supports Compliance Rules which contain Group Based Rules. By mapping these Group Based Rules to the Device Groups you created for the different lookout_threat_level values, you can take policy actions on risky devices based on the severity of the risk.

In the MaaS360 Admin Portal, navigate to SECURITY > Compliance Rules and click Add Rule Set.
In the Rule Set Name field, enter Lookout Risk Rules and click Continue.
Click the Group Based Rules tab and click Add New Rule:
Set the following:
Setting Value
Enter Rule Name
Lookout High Risk
No Group Selected Lookout High Risk Devices
Set the Enforcement Action, notification settings, and custom Message based on your organization’s requirements.
For example, the rule below applies the High threat policy against iOS devices in the group, and the Android High Risk Policy against Android devices:

You can click the + icon beside the Enforcement Action to add more actions as time passes after the original event.
Click the + icon on the right side of the rule to add a new rule.
Repeat Steps 4-6 until you have created rules for high, medium, and (optionally) low risk devices, then click Save.

Setting	Value
Enter Rule Name	`Lookout High Risk`
No Group Selected	Lookout High Risk Devices

lookout-footer

© 2024 Lookout, Inc. LOOKOUT®, the Lookout Shield Design®, LOOKOUT with Shield Design® and the Lookout multi-color/multi-shaded Wingspan Design® are registered trademarks of Lookout, Inc. in the United States and other countries. DAY OF SHECURITY®, LOOKOUT MOBILE SECURITY®, and POWERED BY LOOKOUT® are registered trademarks of Lookout, Inc. in the United States. Lookout, Inc. maintains common law trademark rights in EVERYTHING IS OK, PROTECTED BY LOOKOUT, CIPHERCLOUD, and the 4 Bar Shield Design.

Lookout Product Documentation

Find answers about using and optimizing Lookout products.

Using Lookout Risk Levels to Drive Compliance Rules

lookout-footer